Baileigh Industrial BS-330M, Operator'S Manual

Page: 38 / 68

35
35
Work Stop-Bar Adjustment
The stop bar can be adjusted during angle cutting, and the procedure is as follows:
1. Unfasten the handle (A), and use a hex wrench
(allen wrench) to loosen the hex socket set screw
(B).
2. Push the bar gradually to the right side to get the
desired angle and then tighten the set screw (B) and
handle (A).
Note: There are four presets. They are at
0°, 15°, 30°, and 45° angles.
3. Loosen the handle (C), and according to the scale (D) adjust the length by moving the stop
bracket (E).
4. Retighten the handle (C).
Adjusting Blade Speed
This machine equipped with mechanic variable speed
control device allow for variable blade speed.
Adjust the blade speed while the machine is running.
The dial sticking out of the motor cover (right side)
controls the variable speeds between 66-264FPM
(20-80MPM).
Rotate the governor (A) by following the level (B) in
the scale to get desired speed for cutting the work
piece
B
A
B