Baileigh Industrial BS-330M, Operator'S Manual

Page: 36 / 68

33
33
Setting Up the Machine for Operation
1. Select the proper speed and blade for the type of
material you are going to cut.
2. Make sure blade tension is adjusted properly.
3. Lift the saw bow up and turn OFF the descent
ON/OFF valve (A).
4. Place the material between the vise jaws, set the
material for the desired length of cut and tighten
the vise.
5. Make sure the left blade guide bracket (B) is
adjusted as close as possible to the left vise jaw.
6. Turn the descent ON/OFF valve (A) to the ON
position and turn the descent control valve (C)
counter-clockwise until the saw blade begins to
lower at the desired rate.
7. Proceed to cut through the workpiece. The machine will shut off upon completion of cut.
Adjusting Blade Guide Brackets
The blade guides should be set as close to the vise
jaws as possible. The right blade guide bracket (A)
has limited adjustment to clear the right hand vise
jaw.
The left blade guide bracket (B) can be moved to the
left or right depending on the size of the workpiece.
1. To move the left blade guide bracket (B), loosen
the hand knob, position blade guide bracket as
close to the work piece without interfering with the
material, blade, or vise.
2. Tighten the hand knob.
A
C
B
B
A