Baileigh Industrial BS-330M, Operator'S Manual

Page: 21 / 68

18
18
ASSEMBLY AND SET UP
Drip Tray
1. Unwrap the drip tray and position at the front of the saw.
2. Using the bolts (A) installed in the front of the base, mount the drip tray onto the saw.
3. Using the slotted holes on the tray mount, lift the left end of the tray to tilt the tray so that the
coolant will drain back to the coolant reservoir.
4. Tighten both bolts (A).
Chip Tray
1. Unwrap the chip tray and position at the front of the
saw vise.
2. Loosen the two bolts (A) installed in the front of the
vise.
3. Slide the chip tray slots (B) over the mounting bolts.
4. Position the top of the chip tray so that it is level
with or slightly below the surface of the vise.
5. Tighten both bolts (A).
WARNING:
For your own safety, DO NOT connect the machine to the
power source until the machine is completely assembled and you read and
understand the entire instruction manual.
A
A
A
B