Baileigh Industrial BS-330M, Operator'S Manual

Page: 43 / 68

40
40
11. When you are sure the back of the blade is against the
wheel flanges of both wheels and properly inserted into
the guides, finish putting tension on the blade.
12. Proper tension is achieved when the pointer is on the
inner mark of the blade tension scale (F) behind the fly
wheel.
13. Install and adjust the wire brush to apply light pressure to
the blade.
14. Install the blade guard to the left guide post.
15. Close the cover and guards then fastened securely.
16. Connect machine to power and run unloaded for
approximately 10 – 20 seconds.
17. Turn power off and check, blade tension, blade tracking,
and wire brush adjustment.
18. Close and secure the covers and power on the saw to
run unloaded for approximately two minutes.
19. If further adjustment is necessary, disconnect saw from
power source, make adjustments, and reconnect to
power.
Blade Tracking Adjustment
Blade tracking has been set at the factory and should require no adjustment. If a tracking
problem occurs, adjust the machine as follows.
Since tracking can only be adjusted while machine is running, it is suggested that this
adjustment be accomplished by qualified personnel that are familiar with this type of adjustment
and the dangers associated with it.
1. Start the saw hydraulics.
2. Raise saw arm to its highest position.
3. Open the blade covers to observe the blade tracking on the wheels.
4. Locate tracking adjustment plate on the back side of the idle wheel.
WARNING:
Tracking adjustment is done with the wheel cover open to
observe the blade. Use extreme caution so as not to come into contact with the
blade! This adjustment must be accomplished by qualified personnel that are familiar
with this type of adjustment and the dangers associated with it. Failure to comply
may result in serious injury!
F