Baileigh Industrial BS-330M, Operator'S Manual

Page: 39 / 68

36
36
ADJUSTMENTS
Adjusting Vise Square to the Blade
1. Disconnect the machine from the power source.
2. Place a machinist's square on the table against the blade and the vise (fixed). The Square
should lie along the entire length of the vise and blade without any gaps.
3. If adjustment is necessary, loosen bolts holding the vise and adjust vise so that the square
lines up properly. Tighten bolts.
4. Connect machine to the power source.
Vise and Angle Cutting Adjustment
1. To position the saw arm to cut at 45° angle.
2. Disconnect the machine from the power source.
3. Push the handle (E) forward to unlock the head
assembly.
4. Rotate the head assembly to the desired angle
using the scale (F) to indicate the approximate
angle.
5. Push the handle (E) back to lock the saw at the
desired angle.
6. Properly load the work piece and start operation.
To adjust the angle of the vise jaw:
1. Loosen bolts (C)
2. Adjust the smaller movable vise jaw by rotating it.
3. Slide vise jaw (B) flush to fixed vise (A) to match
parallels.
4. Once parallel tighten bolts (C), then set position.
Setting the position of the vise jaw
1. Pull up on the rack block (D).
2. Move vise to desired location by sliding along table.
WARNING:
Disconnect the machine from the power source before
making any adjustments or repairs! Failure to comply may result in serious injury!
E
F
A