![background image](http://html1.mh-extra.com/html/baby-lock/regalia-blrg20/regalia-blrg20_service-manual_3417908028.webp)
Page 28
Regalia Service Manual
Section 10: Replacing Front Cover
Replace the front cover before adjusting the X axis
needle position.
Â
IMPORTANT: Take special care to not pinch
any wiring when replacing the front cover.
• Plug the front cover wiring harness into the Main
Control board at the rear of the machine .
Check: Assure the small throat LED light strip connec-
tion on the back frame casting will not be pinched
when the cover is replaced.
Check: Assure the small throat LED light strip connec-
tion on the front cover will not be pinched when the
cover is replaced .
NOTE: There is extra cable slack inside the
machine to allow the replacement of the light
strips and reconnection without removing the
front cover of the machine. Take care to keep
the slack inside the machine and not where
the front cover meets the back frame.