![background image](http://html1.mh-extra.com/html/baby-lock/regalia-blrg20/regalia-blrg20_service-manual_3417908021.webp)
BabyLock.com
Page 21
Section 6: Adjusting the Base-Plates and Rollers
Tools required: (5 mm handle Allen)
Check:
The machine must not rock on a flat surface and
the wheels must be the same distance from each
other front to back on both sides of the machine.
NOTE: This is done on a precision surface
plate at the factory during assembly .
If a correction is necessary:
• The rear base plate should be as straight to the
machine as possible. The three baseplate screws
should be tight.
• The front cover baseplate should be as square
to the machine as possible. The two baseplate
screws should be tight on the back casting.
NOTE: If the front cover has been removed
to service the machine, the M10 adjustment
screw should be flush or recessed in the front
cover casting before the front cover is installed
onto the machine .
Check:
Use a ruler or tape measure to check the distance from
the front to rear wheel. The distance should be the
same on both sides of the machine .
If a correction is necessary:
• Slightly loosen the two front base plate screws
and adjust.
• Tighten the two screws firmly before proceeding to
the next step.
Â
IMPORTANT: The two front baseplate screws
must be tightened before tightening the
leveling screw on the front cover casting.