![background image](http://html1.mh-extra.com/html/baby-lock/regalia-blrg20/regalia-blrg20_service-manual_3417908022.webp)
Page 22
Regalia Service Manual
Place the machine on a flat surface or the carriage
tracks. Use a 5 mm hex driver, down through the
casting hole, to lower the front right wheel until the
machine does not rock.
Â
IMPORTANT: If the two front base plate
screws are not tight, or if the M10 screw is
extended out of the casting when the front
base plate is installed and tightened, then
backing of the screw to raise the front right
wheel, will make the front baseplate mounting
screws too loose. These three screws need to
be in tension against each other .
Section 6: Adjusting the Base - Plates and Rollers
(Continued)