4 - 13
Adjustment
In
spection and
Adjustment
Left base line needle drop
[Adjustment standard]
In the test mode “04”, needle top (left base line) must drop in the right side of “V” groove on needle plate. (See
1
below)
[Adjustment procedure]
1. Remove the face plate assy., and the presser foot.
2. Attach the #11 needle.
3. Start the test mode, and then select the “04” (3-point needle drop mode).
4. Press the
button on the screen, and then move needle bar to the left base line.
5. Turn the pulley by hand, until the needle top comes to the needle plate surface.
6. Loose the socket bolt (M3x10).
7. Turn the zigzag adjusting nut and adjust needle top drops in the right side of “V” groove on needle plate.
8. Tighten the socket bolt (M3x10). (tightening torque: 0.78 to 1.18N· m)
*Key point
• Need to adjust “4-34 Camera calibration” after this adjustment.
XE2395001
Box driver 6
Zigzag adjusting nut
Socket bolt (M3x10)
Needle top
drops in
shadow area.
"V" groove
1
32
Summary of Contents for Ellisimo BLSO
