4 - 42
Adjustment
Thread take up spring tension
[Adjustment standard]
The tension (0.15 to 0.19N ; 15 to 19g) when pulling the thread take up spring up with the thread to the right above.
[Adjustment procedure]
1. Remove the thread unit from the arm bed.
*Key point
• Refer to “2-16 Removal of Thread unit”.
2. Remove the bind screw (M3x4) of the plate assembly, and then remove the plate assembly from the thread unit.
3. Fully turn the thread tension gear to the left by hand, then the tension disc open.
4. Loosen the pan head screw (S/P washer, M3x18 DA) of the thread catching case B.
5. Keep up thread catching case A protrusion, then turn thread catching case B (M5;8mm,wrench) counterclockwise
till it stops.
<To next page>
In case replace or disassemble thread take up spring or thread catching case, need to adjust.
Bind screw M3x4
Plate assembly
Thread tension gear
Pan head screw (S/P washer, M3x18 DA)
Protrusion of
the thread catching case A
Thread catching case B
(M5;8mm,wrench)
Thread catching case B
27
Summary of Contents for Ellisimo BLSO
