4 - 12
Adjustment
Upper shaft shutter angle
[Adjustment standard]
In the test mode “22” buzzer stops, when the base line of the pulley is at the top (0 angle).
[Adjustment procedure]
1. Remove the belt cover and the bobbin winder (upper cover assy.).
2. Start the test mode, and then select the “22” (NP sensor mode).
3. Turn the pulley, and set the base line of the pulley to the top.
4. Loosen the socket set screw (CP, M3x6) of the rotation shutter.
5. Rotate the shutter and tighten the socket set screw (CP, M3x6) when buzzer stops (right shutter in NP sensor).
(tightening torque: 0.10 to 0.29N· m)
NP sensor
Shutter
The base line
of the pulley is
at the top.
(0 angle)
*Check that the shutter is
at the position of the left figure.
Socket set screw
(CP, M3x6)
30
Summary of Contents for Ellisimo BLSO
