BASIC EMBROIDERY
25
2
Basic embroidering procedures are described below.
Check the overall procedure below, before operating the
machine.
When the machine is purchased, only the bobbin case is
installed in the hook. Insert a bobbin wound with bobbin
thread for embroidering.
Removing the bobbin case
a
Open the hook cover.
Pull the hook cover toward you.
b
Pull the thread picker toward you if it was not pulled
toward the front.
To gain access to the bobbin case easily, pull the thread
picker toward front.
Chapter
2
BASIC EMBROIDERY
BASIC PROCEDURES
Step
Operation
Reference
Page
1
Turn on the machine.
20
2
Install the bobbin.
25
3
Select an embroidery pattern.
30
4
Edit the embroidery pattern.
37
5
Check the previewed image.
49
6
Hoop the fabric in the embroidery
frame.
50
7
Attach the embroidery frame to the
machine.
54
8
Specify the embroidering settings.
58
9
Checking the position of the pattern.
62
10
Thread the upper threads.
63
11
Touch the “Start/Stop” button to start
embroidering.
69
12
Remove the embroidery frame.
70
13
Turn off the machine.
21
INSTALLING THE BOBBIN
IMPORTANT
• Be sure to use prewound bobbins (Fil-Tec/
TRU-SEW POLYESTER “Filaments”), the
included metal bobbins or bobbins designed
specifically for this machine.
Note
• Before starting to embroider make sure that there
is enough bobbin thread for the pattern.
• Make sure to clean the bobbin case every time the
bobbin is changed. (page 95)
1
Thread picker
Memo
• Thread picker is a device that is used to hold the
thread when beginning to embroider or when
trimming the thread.
