GETTING READY
19
1
f
Press down on each corner of the machine to check
that it is stable.
If it is still unstable, perform steps
c
through
e
again
to adjust the legs.
Preparing the thread guide assembly
Assemble the thread guide assembly. Locate the included
Phillips screwdriver.
a
Remove the two screws from the thread guide
assembly support.
b
Slide the thread guide assembly support onto the
machine, and then tighten the screw, until the thread
guide assembly support is secure.
c
Tighten the screw on the opposite side of the thread
guide assembly support in the same manner.
Attaching the Embroidery Frame Holder
a
Use the Embroidery Frame Holder appropriate for the
embroidery frame that you are using. (page 55 to
page 57)
b
Remove the two thumb screws of the Embroidery
Frame Holder.
1
Thumb screws
2
Corner covers
c
Align the holes in the Embroidery Frame Holder with
the pins on the frame-mounting plate of the carriage.
1
Pins on the frame-mounting plate
2
Holes in the Embroidery Frame Holder
3
Corner covers
Note
• Do not apply extreme force when moving the
thread guide assembly support and thread guide
assembly.
• Be sure to tighten each screw well enough that the
thread guide assembly is secured.
Note
• Using the 3-way screwdriver included, loosen and
firmly tighten the thumb screws.
1
Use this part to tighten the thumb screws of the
Embroidery Frame Holder.
a
