DUO
DMX
GATEWAY
DUO
DMX
GATEWAY
BAB TECHNOLOGIE GmbH 17
SAVING THE CONFIGURATION via SD card:
Close and acknowledge the configuration with OK.
Save the project (
File
>
Save
or
Save as
)
Open the
File
menu again and save the project by means of
the
Export HEX File
under a unique name in the desired
folder.
Insert your SD card in your card reader and make sure that
the SD card does not contain any data.
Then copy the generated HEX file onto the SD card and
rename it to “
config.par
”.
Insert the SD card into the slot of the DUO
DMX
GATEWAY
during operation. The status LED of the device will go out for
a
short while for reading the data.
As soon as the green status LED is on again, the configuration is loaded.
Please note: Only SD cards with FAT file system format are supported!
Third and last step of the network configuration:
Restart the device by pressing the power button.
Open the
DMX-Configurator
and check, as described in the steps above, whether the new IP
address settings have been applied to the DUO
DMX
GATEWAY. From now on, you can transfer
any configuration changes directly via the network (see
chapter “
Transmission of configuration
files”
).
Further information is provided in chapter 5.5.2.3. LAN/KNX
Figure 11: Saving the project
