Programming
DUO
DMX
GATEWAY
42 BAB TECHNOLOGIE GmbH
DUO
DMX
GATEWAY
5.5.2.3
LAN/KNX
The settings specific for the network and for KNX are made in the
LAN/KNX
tab.
IMPORTANT NOTICE: In case that DUO DMX cannot be found, you must deactivate all network
interfaces except for the currently used network interface!
Figure 39: KNX DUODMX GATEWAY
1.
Activating/deactivating DHCP
2.
IP address setting and KNXnet/IP (routing) multicast group.
3.
List of the DUO
DMX
GATEWAYs available in the network. Is reloaded by pressing the
Search
button. The corresponding gateway is indicated together with its IP address, the assigned name
and the current firmware version number (as of firmware 2.0.0.1). If the device has not yet been
assigned a name, its MAC address is indicated. With a mouse click, you can mark a device for the
configuration data upload or the activation of the unicast preview.
4.
Press the
Search
button to show all DUO
DMX
GATEWAYS available in the network. Once the
desired device has been marked in the list and the
Upload
button has been pressed, all current
configuration data are transmitted to the device via the network (PC and DUO
DMX
GATEWAY
must be in the same IP address range).
5.
You can specify at this point, for which of the both DMX interfaces you want to enable the
preview. The preview is not enabled until you have ticked the check box (
broadcast preview
). If a
device is also marked in the
DMX Gateways
list, the preview is only applicable to this device
(
unicast preview
). In this case, the PC and the gateway must be in the same network range
(subnet). (See also
chapter
“Enabling the DMX preview”
).
6
8
1
3
4
5
2
7