DUO
DMX
GATEWAY
DUO
DMX
GATEWAY
BAB TECHNOLOGIE GmbH 45
Figure 41: Configuration for DMX slave
By activating the check box, the corresponding DMX interface is switched to slave mode. A DMX master
(DMX light control panel), for example, can be connected to this DMX interface.
Thus, commands are received from the DMX via the
SLAVE
DMX interface and forwarded to KNX.
See the following example. The configuration shows how a KNX actuator is controlled via a DMX mixing
desk.
The DMX mixing desk is connected to the DMX interface 2 (see red rectangle;
Out 2
is selected as the
slave (red arrow)).
In the
Dimmer Out 2
tab, the KNX group address 1/1/1 (EIS6, 1 byte) is assigned to the DMX channel 1
(orange arrow).
Thus, the received dimming value from the DMX channel 1 (0%-100%) is directly forwarded to the KNX
group address 1/1/1.
