DUO
DMX
GATEWAY
DUO
DMX
GATEWAY
BAB TECHNOLOGIE GmbH 55
5.5.6
CHANGING THE IP ADDRESS CONFIGURATION
To change the IP address settings of an already commissioned device, please proceed as follows:
Please note: For configuration, the PC must be in the same IP address range as the DUODMX
GATEWAY.
If it is not possible to change the network settings of the PC, you can alternatively transfer the
network settings by means of an SD card.
If you have selected
KNX/BMX
and
KNX/BMX master/slave
, switch to the
LAN/KNX
tab, if you
have selected
EnOcean
, switch to the
LAN/EnOcean
tab, and if you have selected
WLAN
, switch
to the
WLAN
tab. The figure below shows the configuration for the
KNX/BMX
as an example.
Press the
Search
button below the
DMX-Gateways
field. All DUO
DMX
GATEWAYs in the network
are displayed, irrespective of the IP address settings of the local PC.
Figure 50: DMX-Configurator – LAN/KNX window
Note: If the device is not on the list even if after having pressed the
Search
button, you probably
have a problem with your network configuration (e.g. firewall / router settings), or you have
activated two network cards at the same time. Please check. In case of doubt, please contact the
BAB Technologie support!
Check the pre-set IP address of the Gateway in the
DMX Gateways
window.
To provide the DUO
DMX
GATEWAY with a new configuration, you must adjust the IP address
range of your PC so that it corresponds to the address range of the DUO
DMX
GATEWAY.
