B9Creations B9 Scan 500, Operating Manual

Page: 50 / 54

B9 Scan 500 Operating Manual Page50
1 Turn on the back main On/Off AC switch
2 Turn on the scanner by using the front On/Off switch
3 Wait until warm up sequence is finished and Windows desktop appears
Reset tray position
1 Remove any model from the scanner
2 Double click on the B9 Scan icon on the desktop
3 Click on Reset tray position icon
4 Wait until a dialog box confirms the end of the process
Calibration
1 Put the calibration plate in the scanner on the long spacer
2 Double click on the B9 Scan icon on the desktop
3 Click Main menu -> Calibration
4 Click the "OK" button in the "Calibration Mode" dialogue box
5 Wait a few minutes until a dialogue box confirms the end of the process
Acquisition
1 Place properly the model or impression in the scanner
2 Double click on the B9 Scan icon on the desktop
3 Click on the "Scan" button
4
Select the model type, the acquisition Cycle, "From Top" and "Detail ” parame-
ters in the dialogue box
5 Click on the "Scan" button to start the scanning process
6
Observe the acquired points. If required stop the process with the "Stop" but-
ton and repeat the acquisition with a different set of parameters
7 Click on the "Finalize" button to transform the points into a mesh
Putting out of operation
1 Remove the model from the scanner