B-TEK Scales T403S, User Instructions

Page: 68 / 74

68 BTEK T403S Indicator User Instructions
Supervisor menu
7.6 Peak Hold application supervisor menu
Figure 7.6 shows the Supervisor menu when you are in the Peak Hold application:
Figure 7.6 Supervisor menu for the Peak Hold application
7.6.1 Peak hold
Super  Setpoint  P-hold
1. With the Peak Hold application active, access the Supervisor menu using
password 1793. Refer to
Accessing the menus on page 30 for instructions.
From SuPEr , press SELECT …
SEtPnt is displayed.
2. Press UNITS twice …
P-hoLd is displayed. Use this to reset the min/max peak. If the F1 key is
disabled, which is the normal key to reset min/max, the supervisor
needs an alternate method to reset these values.
The Setpnt and bAttErY submenus in Figure 7.6 are the same as described in
General Weighing application supervisor menu on page 45 . Go there for information
on those submenus. The unique submenus to this application are described below.
Super
Setpnt
Off On
Edit Print Reset
Annun Out1 Out2 Out3 In1
No Yes
In2 In3
None Print
Units Select Tare Zero Sample F1 Target Start
Stop ID Setup Under Over Accu
Port 1
Battery
Enable
Tmout
Off On
P-hold
Reset
No Yes
Port 2 USB
PrntHld
Mode
Act Abv Act Bel
User
Key
in
value
Key
in
value
Key
in
value
Bold boxes and text
denote defaults.
1-3600
minutes
SELECT =
TARE =
PRINT =
UNITS =
ZERO =
F1 = Escape or