B-TEK Scales T403S, User Instructions

Page: 46 / 74

46 BTEK T403S Indicator User Instructions
Supervisor menu
7.1.1 Setpoint
Super

Setpoint
1. With the General Weighing application active, access the Supervisor menu.
Refer to
Accessing the menus on page 30 for instructions. From SuPEr , press
SELECT …
SEtPnt is displayed. Use this to:
l
set the function of the setpoint annunciators
l
enter up to three setpoint values
l
select inputs for up to three inputs
l
set the mode of setpoint operation
l
print the setpoint settings
l
reset all setpoint settings to factory defaults.
Annunciators
Setpoint  Edit  Annun
2. Press SELECT …
Edit is displayed.
3. Press SELECT …
Annun is displayed. ( Annun is not included in the Batch application
Supervisor menu. Skip steps 3 through 5 ).
This stands for annunciators, referring to the SP1 , SP2 and SP3 setpoint
annunciators. By default ( oFF ) these annunciators are ON when the
displayed weight is below the setpoint value or OFF above the setpoint
value. If you select
on , the annunciators work in the opposite fashion--
OFF when below, ON when above.
The  and  symbols used in this section stand for direction moved in the menu. So
Super  Setpoint, shown above, illustrates that you move down from SuPEr to
SEtPnt . This will help you keep track of where you are in the menu structure.
If you are using a battery operated indicator with any application, setpoint output #3
can be configured for shutting down the battery for power saving. See the Service
manual for information on setting up setpoint outputs and optional power saving
circuitry you can create to shutdown power from a battery.
The ZM-BAT (the optional
D-cell battery pack) made for the T403S does not contain the power saving
circuitry.
A setpoint value can be entered ranging from +/- scale capacity. See Entering a
negative number on page 11 for the negative numeric entry process.
Turn off or disable any setpoints you are not using. See the Service manual for
information on disabling or turning off setpoints.