B-TEK Scales T403S, User Instructions

Page: 63 / 74

BTEK T403S Indicator User Instructions 63
7.5 Batching application supervisor menu
7.5 Batching application supervisor menu
Figure 7.5 shows the Supervisor menu when you are in the Batching application:
Figure 7.5 Supervisor menu for the Batching application
Follow these steps to set the items in the Supervisor menu.
7.5.1 Batch
Super  Setpoint  Tare  Batch
1. With the Batching application active, access the Supervisor menu using
password 1793. Refer to
Accessing the menus on page 30 for instructions.
From SuPEr , press SELECT …
SEtPnt is displayed.
Super
Setpnt Tare
Edit Print Reset
No Yes
Edit Print Reset
No Yes
Tare 1 Tare 10
Batch
Type Mode Disp Preact Neg Fil
Off On
Auto Manual Clear
Net Gross
Auto
Manual
2 Speed Ingred Indep Fil-DSC
Battery
Enable
Tmout
Off On
Out1 Out2 Out3
Units Select Tare Zero Sample F1 Target Start
Stop ID Setup Under Over Accu User
Port 1 Port 2 USB
Port 1 Port 2 USB
In1 In2 In3
None Print
Preact1 Preact2 Preact3
PrntHld
Bold boxes and text
denote defaults.
Appears only if Preset
Tare is enabled
1-3600
minutes
Key
in
value
Key
in
value
Key
in
value
SELECT =
TARE =
PRINT =
UNITS =
ZERO =
F1 = Escape or
Key
in
value
Key
in
value
Key
in
value
The Setpnt , Tare and bAttErY submenus in Figure 7.5 are the same as described in
General Weighing application supervisor menu on page 45 . Go there for information
on those submenus. The unique submenus to this application are described below.