Hot Surface
High Voltage
Warning
Standard Adjustment
HP2/CO2
LED (18W-29W)
Flammable
IMPORTANT SAFETY INFORMATION - READ, FOLLOW, AND SAVE THESE INSTALLATION
INSTRUCTIONS
THIS DOCUMENT CONTAINS PROPRIETARY INFORMATION OF B-K LIGHTING, INC. AND ITS RECEIPT OR POSSESSION DOES NOT CONVEY ANY RIGHTS TO REPRODUCE, DISCLOSE ITS CONTENTS, OR TO MANUFACTURE, USE OR SELL
ANYTHING IT MAY DESCRIBE. REPRODUCTION, DISCLOSURE OR USE WITHOUT SPECIFIC WRITTEN AUTHORIZATION OF B-K LIGHTING, INC. IS STRICTLY FORBIDDEN.
RELEASE DATE
06/10/2023
40429 Brickyard Drive • Madera, CA 93636 • USA
559.438.5800 • FAX 559.438.5900
www.bklighting.com • [email protected]
B-K LIGHTING
REFERENCE NUMBER
INS-2405-01
1. Remove faceplate using a 1/8” allen wrench.
Remove optional accessory holder (if applicable).
2. Turn, then lift OptiLock from housing. Disconnect
OptiLock assembly from driver assembly using
quick disconnect.
3. Remove optic by turning to the left and lifting up.
Remove the optic holder from the LED board by
loosening three (3) optic holder fasteners using a
0.050” allen wrench.
6. Attach OptiLock assembly to installed driver
assembly with quick disconnect. Place OptiLock
assembly in housing, resting the OptiLock on the
pins provided inside the housing. Gravity will hold
OptiLock in place.
4. Use a 0.050” allen wrench to loosen three (3) #2-56
screws on LED component. Reverse install new
LED component. Ensure LED component is firmly
seated on heatsink.
LED component can only fit
in one direction.
5. Install optic holder with three (3) optic holder
fasteners using a 0.050” allen wrench. Reverse
install optic.
10. Install faceplate using a 1/8” allen wrench and
hand-tighten the faceplate screws in a star pattern
to 30 in-lbs. min.
Do not use a power tool to install screws. Do not
exceed 40 in-lbs.
9. Remove any dirt or debris in o-ring groove near top
of housing. Place o-ring inside of groove.
Failure to clean groove of debris will cause fixture
to fail and void product warranty.
7. To aim OptiLock horizontally: lift OptiLock from
resting position, and rotate to desired angle. Set
down on pins provided in housing. Gravity will hold
OptiLock in place.
8. To aim OptiLock vertically: loosen two (2) 1/4-20
screws using a 3/16” allen wrench. Tilt swivel arm
with LED and optic in desired aiming direction.
Tighten two (2) 1/4-20 screws with a 3/16” allen
wrench to secure position.
1/8”, 3/16” & 0.050” Allen Wrench
Phillips Screwdriver
Torque Wrench
TOOLS
NEEDED:
