![background image](http://html1.mh-extra.com/html/b-k-lighting/co2/co2_standard-installation_3052662007.webp)
IMPORTANT SAFETY INFORMATION LISTED ON REVERSE
READ, FOLLOW, AND SAVE ALL SAFETY AND INSTALLATION INSTRUCTIONS
RELEASE DATE
06/10/2023
40429 Brickyard Drive • Madera, CA 93636 • USA
559.438.5800 • FAX 559.438.5900
www.bklighting.com • [email protected]
B-K LIGHTING
REFERENCE NUMBER
INS-2405-02
Standard Adjustment
HP2/CO2
LED (31W-52W)
14. Install faceplate using a 1/8” allen wrench and
hand-tighten the faceplate screws in a star pattern
to 30 in-lbs. min.
Do not use a power tool to install screws. Do not
exceed 40 in-lbs.
13. Remove any dirt or debris in o-ring groove near top
of housing. Place o-ring inside of groove.
Failure to clean groove of debris will cause fixture
to fail and void product warranty.
11. To aim OptiLock horizontally: lift OptiLock from
resting position, and rotate to desired angle. Set
down on pins provided in housing. Gravity will hold
OptiLock in place.
12. To aim OptiLock vertically: loosen two (2) 1/4-20
screws using a 3/16” allen wrench. Tilt swivel arm
with LED and optic in desired aiming direction.
Tighten two (2) 1/4-20 screws with a 3/16” allen
wrench to secure position.
10. HP2 Accy Holder Installation/Removal
For Optional Accessory Holder: Loosen the
thumbscrew and then tilt the Accessory Holder
up off the reflector so the second screw can clear
the edge of the reflector.