7-1
Chapter 7.
PARAMETER SETUP
7 - 1
Parameter Setup
Parameter settings can be changed when the
DCP551
is in the normal display mode.
When not in the normal display mode, press the
DISP key
to invoke it.
■
Selecting parameter settings groups
In the normal display mode, the keys listed in the table below can be used to select
settings groups and individual items in these groups.
Individual items in each settings group are listed below.
Variable parameter
:
PA01
Event configuration data
:
E01-t
PID parameters
:
P-1
in READY mode
Use
P
setting in the used PID group in modes other
than READY mode.
Setup data
:
C01
Constant value control data :
ConSt
when using
FUNC + PID key
SP
when using the
PID key
in constant value
control mode
■
Progression of individual items in parameter settings
The item codes for individual (specific) items are shown on display panel 1, their
set values are shown on display panel 2 and their mnemonic codes are shown on
the message panel.
Individual items are displayed in the vertical-horizontal matrix shown on the
following page, with matrix sizes varying according to settings group. The
key
,
key
,
key
and
key
are used to cycle through individual items.
The
PARA key
(valid for variable parameters and event configuration data),
PID
key
(valid for PID parameters and constant value control data) or the
SETUP key
(valid for setup data) allow you to search for displayable items in ascending order
of item number.
PARA key
Variable parameter
Constant value control data
Setup data
Constant value control
data (does not include
ConSt)
PID parameter
Event configuration data
FUNC + PARA key
PID key
(In program run mode)
PID key
(In fixed command
control mode)
SETUP key
(In READY mode)
FUNC + PID key
(In READY mode)
Setting: not displayed when variable parameter
PA01 setting is more than 1
Setting: not displayed when variable parameter
PA01 setting is more than 1
Setting: not displayed when variable parameter
PA01 setting is more than 1
Setting: not displayed when variable parameter
PA01 setting is more than 0
Setting: not displayed when variable parameter
PA01 setting is more than 1
Normal display mode
