83
Transducer Block “DISPLAY”
Parameter
Write access
with operating
mode (MODE_
BLK)
Description
Display source x
DISP_SOURCE_X
AUTO - OOS
For selecting the value to be displayed. Possible
settings:
Off .Primary Value 1
Sensor Value 1
Primary Value 2
Sensor Value 2
RJ Value
Note: If all 3 display channels are switched off
('Off' option), the value for pri.mary value 1
automatically appears on the display. If this
value is not available (e.g. ‘No Sensor’ option
selected in the Sensor Transducer Block 1
parameter 'SENSOR_TYPE'), primary value 2
is displayed.
Display value
description x
DISP_VALUE_X_
DESC
AUTO - OOS
Description of the display value displayed.
Note: Maximum 12 letters. The value is not shown on
the display.
Decimal places x
DISP_VALUE_
X_FORMAT
AUTO - OOS
For selecting the number of places displayed after the
decimal point.
Configuration option from 0 to 4. The option 4
means ‘AUTO’. The maximum number of decimal
places possible always appears on the display.
Possible settings:
- Auto
- xxxxx
- xxxx.x
- xxx.xx
- xx.xxx
1.X = number of the display channel in question (1 to 3)
Configuration example:
The following measured values should be shown on the display:
Value 1:
Measured value to be displayed: Primary Value of Sensor Transducer 1 (PV1)
Measured value unit:
° C
Decimal places:
2
Value 2:
Measured value to be displayed: RJ Value
Measured value unit:
° C
Decimal places:
1