Axminster Trade AT254PS13, Manual

Page: 8 / 52

Assembly
8
PLEASE NOTE: Some of this assembly
procedure is best accomplished by two
persons, some of the items are heavy and
awkward, and a mishandling error could
cause injury. Please think about what you are doing,
your capabilities and your personal safety.
Unpack all the boxes, see fig 01-02-03 and check all the
components against the ‘What’s Included’ list. If any
parts or components are missing, please contact our
customer service department using the procedures
and telephone numbers listed in our catalogue, and
you will be dealt with quickly and efficiently.
Fig 01-02-03
Remove the polyurethane block from around
the motor assembly, see image above.
Remove all the components from inside the saw frame
PLEASE NOTE: The panel saw comes 80% assembled,
in order to reduce the footprint of the machine for
packaging, several items are dismounted from the
machine and need to be re-affixed. Please check all
the boxes, packets etc, to make sure that all the parts have
been accounted for.
Having unpacked the boxes, (please dispose of any
unwanted packaging responsibly), put the parts and
components where by they are readily to hand. Break
down the main box by knocking the sides away (be
careful of exposed nails etc.), but leave the machine
sitting on its pallet. Remove the protective grease film
that is coating all the unpainted parts of the machine.
Use a proprietary de-greasing agent. Unfortunately, this
cleaning process is always a bit ‘mucky’. You are advised
to wear overalls or coveralls etc., during the process.
After cleaning, lightly coat the exposed metal surfaces
with ‘anti rust’ oil spray to prevent any rusting.
Main Saw Body
Identify the side, back and front panels (2), lower leg
columns (3), dust extraction moulding (17) and M8 x
20mm Hex bolts, washer and nuts (A).
1. Locate the four leg columns (3), place a column on top
of the upper legs on the man saw assembly (1). Using
four M8 bolt,wahers and nuts (A) secure the columns in
position, see fig 01-02.
Fig 01-02
3
A