Axminster Trade AT254PS13, Manual

Page: 14 / 52

Assembly
14
Fig 40-41
Fig 42
Sliding Table
NOTE: YOU WILL REQUIRE HELP FOR THIS
NEXT STEP!
6
Bolt/washer
Fig 43-44
‘T’ bolt
Support bracket
10
24. Open the side access door to gain access to the
support brackets and using the supplied spanner (E)
securely tighten the two ‘T’ bolt nuts, see fig 45-46.
Fig 45-46
10
Spanner (E)
You will require the following: the sliding table extension
support arm (27), sliding table assembly (10), sliding table
fence (24), sliding table extension (11), mitre fence (14)
for sliding table, workpiece support shoe (23).
21. Remove the four bolts and washers from the bottom
corner of the main saw table’s frame, see fig 40. Locate
the extension support arm (6), line up the holes in the
support bracket with the holes in the saw frame and
secure with the bolts/washers you removed earlier, see
fig 41.
22. Loosen the two ‘T’ bolts/nuts and washers from the
angled support brackets on the main saw (1), see fig 42.
23. With assistance, insert the first ‘T’ bolt into the
machined slot to the end of the sliding table assembly
(10). Slide the table on and repeat the process to the
opposite end of the main saw table (1), see fig 43-44.
Position the sliding table (10) so its over hangs equally
to both end of the main table (1).