Axminster Trade AT254PS13, Manual

Page: 11 / 52

Assembly
11
Side Access Door Knob (If not already assembled)
11. Introduce the threaded knob through the pre-drilled
hole in the side access door, slot the washer over the
thread and secure the knob in place with the nut, see fig
20-21.
Fig 20-21
12. Locate the rear extension table (5) and two
M8x20mm Hex bolts and washers (A). Lift the table up,
line up the pre-drilled holes with the threaded holes to
the rear of the main saw table (1). Introduce a bolt with a
washer through one of the holes in the rear table (5) and
screw it into the threaded hole in the main table. Lightly
finger tighten. Repeat the process for the remaining bolt/
washer. Place a straight edge across both tables and
gradually tighten the bolts until both tables are level, see
fig 22-23.
Fig 22-23
13. Locate the side extension table (4) and four
M8x25mm Hex bolts and washers (A). Lift the table up,
line up the pre-drilled holes with the threaded holes to
the side of the main saw table (1). Introduce a bolt with
a washer (A) through one of the holes in the side table
(4) and screw it into the threaded hole in the main table.
Lightly finger tighten. Repeat the process for the remain-
ing bolts/washers. Place a straight edge across both
tables and gradually tighten the bolts until both tables
are level, see fig 24-25-26.
Rear Extension Table
5
5
1
Straight edge
Side Extension Table
10. With everything secure, with assistance
tip the main saw over towards its blind face
until it is resting on the pallet. With its legs on
the floor lift the machine upright, see fig 19.
Fig 19
A
Fig 24-25-26
4
1
Continues Over....