Axminster Trade AT254PS13, Manual

Page: 15 / 52

Assembly
15
25. Locate the sliding table extension (11), line up the
two ‘T’ bolts on the extension table with the ‘T’ slots to
the side of the sliding table (10) and slide on the
extension table, see fig 47. Open up the supporting arm
(6), insert the extension table mounting bracket onto
the threaded pin/bolt on the supporting arm, see fig 48.
Using a spanner turn the bolt beneath the supporting
arm (6) to lock the two components together, see fig 49.
Lock the extension table (11) in place with the two lift
and shift handles, see fig 50.
Fig 47-48-49-50
26. Locate the sliding table supporting leg (27), loosen
the square bolt on top of the leg support. To the
underside of the sliding table (10), Insert the square bolt
into the ‘T’ slot to the end of sliding table assembly. Ro-
tate the leg, clockwise to secure the leg in position,
see fig 51.
27. Using a Hex key loosen the Hex screw to the centre of
the leg and adjust the leg until the foot is resting on the
floor, retighten the screw, see fig 52-53.
Fig 51-52-53
28. Put to hand the sliding table fence assembly (24),
remove both the steel clamping knob (A) and butterfly
knob(B) with washers from the fence and place to one
side. Lower the fence on top of the table extension (11),
insert the larger threaded pin into one of the pre-drilled
holes to the corners of the table extension (11). Insert
the other between the centre column of the table then
replace the clamping knobs and washers you removed
earlier, see fig 54-55-56-57-58. NOTE: Don’t tighten at
this point.
11
6
‘T’ Bolt
Threaded pin/bolt
Mounting bracket
11
Square bolt
10
‘T’ Slot
27
Hex screw
Foot
Lift & shift handles
Continues Over....