Axminster Trade AT254PS13, Manual

Page: 17 / 52

Assembly
17
32. Loosen the ‘T’ bolt in the sliding table’s operating
handle (25). Insert the ‘T’ bolt into the ‘T’ slot into the
opposite end of the table and secure in place, see
fig 64-65.
Fig 64-65
33. Locate the overhead clamp and shaft (28). Remove
the mounting bar (a) from the sliding table. Slide the
shaft with the ‘T’ bolt into the ‘T’ slot to the centre of the
table and secure in place by rotating the shaft. Insert one
of two pre-drilled holes in the overhead clamp assembly
down over the shaft and lock in place with the clamping
knob, see fig 66-67.
Fig 66-67
25
‘T’ Bolt
‘T’ Slot
10
28
Shaft with ‘T’
mounting bolt
Clamping knob
You will require the following: the rip fence (9), rip fence
rail (7), micro adjuster (8), capping plates (D), small Phillips
screws (E) and the three M8x 25mm square head bolts/
washer/nuts (B).
34. Put to hand the fence rail (7) and square bolts (B).
Remove the washers and nuts and place safely aside.
Insert the square bolts into the machined holes to the
front of the main saw table (1) and replace the washers/
nuts you removed earlier. (Leave the bolts loose for the
next stage), see fig 68-69.
Rip Fence
Fig 68-69
35. Attach the capping plates (D) to the fence rail (7) as
shown in fig 70. Introduce the furthest right hand square
bolt (B) into the channels ‘T’ slot to the side of fence rail
(7) and slide on. Repeat for the remaining bolts, see fig
71-72.
Fig 70-71-72
7
B
Capping plate
B
1
D
E
Channels ‘T’ Slot
a
Loosen the
grub screws
Continues Over....