Section 2: Basic Installation
AXIS StorPoint HD
13
User’s Manual
Step 1 - Installing StorPoint HD/T in a Tower
The AXIS StorPoint HD/T is intended to be installed in standard
tower systems. The dimensions of the StorPoint HD/T are the same as
for standard drives, i.e. 5.25 inch half-height.
If not already installed when delivered, follow the steps below:
1.
Prepare the tower system for the installation, e.g. by removing the
chassis.
2.
Record the serial number of the StorPoint HD/T. You will need this
number during the network configuration described in “Section 3
-
”. The number is found on the underside
label of the server.
3.
Slide the StorPoint HD/T into the tower.
4.
Fix the StorPoint HD/T with the four screws supplied. Use the
upper or lower holes depending on type of tower and mounting. See
figure below.
Caution
0
❏
The length of the screws must
not
exceed 0.2 inch (5 mm). If they
do, the internal components of the StorPoint HD/T may be
damaged.
