Operation Instructions | EoC 10-01 | Ethernet over Coax | Master
20
2018-06-25 | Technical improvements, changes in design, printing- and other errors expected.
Config:
1. configure EoC Master G.hn(Ethernet) properties and configure EP G.hn(Ethernet)/WiFi
properties. EOC 10-01 will keep these Master/EP settings into its own nonvolatile memory as
profile and use the settings profile to configure device accordingly while power up. Refer
“Setting Profile”.
2. configure the “User Defined EP Default Profile”
3. run the EOC 10-01 built-in EP diagnostic functions. Refer “EP Diagnosis” for more detail.
Upgrade EoC: upgrade the selected Master/EP(s) EoC driver with new driver resides at the EOC 10-01 upload
area .
Upgrade WiFi: upgrade the selected EP(s) WiFi driver with the new one resides at the EOC 10-01 upload area.
ReConfig:
force to configure EP G.hn(Ethernet)/WiFi settings (stored in EOC 10-01) again, sync the EP
internal settings to what EOC 10-01 has. EP will reboot then.
Add EP :
add the off-line EP setting profile, setup in advance EP G.hn(Ethernet)/WiFi setting profile before
it goes on-line.
Del EP:
delete the off-line EP setting profile, to save the EP setting profile space in EOC 10-01 NMU.
Click on each device’s ‘Config’ button can open the window to configure its G.hn(Ethernet)/WiFi properties.
Link in Green – EP is ready
EP has been configured properly by EOC 10-01.
Link in Yellow – EP is being configuring
Then turns into Green while EOC 10-01 finishes the initializing/configuring of EP.
Link in Red – unrecognized/configure-failed EP
It is a broken, unauthorized or configure-failed EP, and may degrade the whole EoC connection quality. The EP
should be checked.
Link in Gray – EP is power off
Background in Pink – banned EP
‘
Host Limit
’ value in EP is 0. EOC 10-01 will refuse to serve this EP. Host(User) at this EP cannot reach the
Ethernet link of EOC 10-01 (toward ISP) through EoC coax.
