Operation Instructions | EoC 10-01 | Ethernet over Coax | Master
6
2018-06-25 | Technical improvements, changes in design, printing- and other errors expected.
1.3. Features
∂
One TV/Antenna port for TV Set Connection or for TV Signal from VHF/UHF Antenna/CATV
∂
Two Gigabit Ethernet Ports with Auto-Detect MDIX Function(Auto Crossover) and Auto-Negotiating
Half/Full Duplex 100M/1000Mbps
∂
Built-in Power over Ethernet(PoE) Powered Device(PD) Function in One Ethernet Port
∂
One Small Form-Factor Pluggable(SFP) Socket for Expansion to FTTx or PON
∂
One Rocker Switch to Select either Local or Line Power Mode
∂
One Reset Button
∂
Built-in Network Management Unit(NMU) and EoC Master
∂
One EoC Master that Supports up to 31 EP
∂
Built-in On-line Diagnostic Function for Individual EP Connection SNR(Signal to Noise Ratio), CFR(Channel
Frequency Response), and PE(Payload Encoding equals Carrier Speed in Mbps).
∂
Supports Dual Stack IPv4/IPv6
∂
Priority Queue based QoS(Quality of Service) Support for 802.1p, IP TOS/TC or DSCP, UDP/TCP Protocols
∂
Built-in Web/Telnet Server to Support Remote Configuration
∂
Supports Remote HTTP/TFTP Upgrade Function for System NMU Firmware, EoC Master/EP Driver and EP
WiFi Driver
∂
Supports NMU/Master/EP Auto-Configuration via Built-in TFTP/DHCP Client
∂
Supports DHCP/IGMPv2 Snooping for Host at EP
∂
Supports SNMP Function
1.4. LED Indicators:
Label
Status
ON
Flashing
Power
Powered by DC12V
N/A
LAN1
Green = LAN1 port is active
Data traffic active
Orange = LAN1 = 1Gbps.
LAN2
Green = LAN2 RJ-45 port is active
Data traffic active
Orange = LAN2 RJ-45 links at 1Gbps.
Diminished if LAN2 links at SFP
Link/Act
Data+RF port is active
Data traffic active
Quality
Green = high EoC throughput
Orange = medium EoC throughput
Red = low EoC throughput
Diagnosis
EoC 10-01 is diagnosing EoC
connection toward/from EP
Not labeled
Forcing to default settings via reset
button.
Bootloader mode
SFP
SFP port is active
