Ethernet will set the network settings for the CON300-IP. Follow instructions below:
1.
If you have a DHCP server connected with your network, set this feature to ON.
2.
Set the IP address to connect the CON300-IP to your local network. Use the
and click the
to confirm.
3.
Set the subnet mask using the number buttons and click the Joystick button.
4.
Set the Gateway using the number buttons and click the Joystick button.
Serial Port
The Serial Port option can be used to set the Baud Rate.
The Baud Rate must match exactly the Baud Rate setting in the camera.
Follow instructions below:
1.
Move the joystick up and down to choose a channel (even if you have chosen an address to
connect with the camera).
2.
Set the Baud Rate for that channel to control the camera.
3.
Set the Instruction Repeater to the channel you just set the baud rate for.
(Zoom) Rocker
With the (Zoom) Rocker setting it is possible to synchronize the picture for multiple cameras.
Follow instructions below:
1.
Use the Joystick to Enter the PAN reverse feature. And use the Joystick again to set the PAN
reverse OFF or ON. The same can be done for the TILT reverse feature.
2.
Enter
Zoom Rocker calibration
to calibrate the PAN and TILT reverse feature. Press [Zoom Tele]
hard and release it. Then press the
. Do the same with [Zoom Wide].
3.
Enter
Joystick calibration
. A warning appears that you must not touch the Joystick for 5
seconds. After that the JOYSTICK is automatically calibrated and a screen is popping up that
the calibration was successful.
Buzzer
User Manual AV-CON300-IP
| www.avonic.com
24
