CRANE
CO.
280
N.
MIDLAND
AVE.,
STE
258,
SADDLE
BROOK,
NJ
07663
WWW.AVIDCONTROLS.COM
12/17/12
TECH-440/D.W.O. 23135
Page 23 of 55
4.3 Proceed to Exiting Calibration or Perform Advanced Calibration
After the completion of an Automatic Calibration (ACAL) the calibration of the positioner
is complete. The Automatic Calibration that was performed in Section 3 is adequate for
most applications. If no advanced calibration is required proceed to Section 5 to exit
calibration. If the user requires using the advanced settings to fine tune the positioner he
may proceed with the remainder of this step and perform adjustments and calibrations in
the Manual Calibration Menu (MCAL). From the menu level press the down arrow button
until MCAL is shown on the display (MCAL Routine shown below).
