9
TT-830 Bench Scale Service Manual
Press the
CLOCK
soft key to access the time and date setting function.
1.
The display shows the current
hour value. If this is not correct
key in a new value and press
ENTER
or press
ENTER
to
accept the current value. . .
The display shows the minutes
value.
2.
Repeat step 1 for minutes,
seconds, year, month, and
day. . .
Display returns to display shown in
Figure 3.
Press the
SELECT
soft key to access the USER-SELECT soft key group:
• DISP
Press this key to set the current display mode.
• SCALE
Press this key to select the scale number you want to use.
• TARE
Press this key to enter a known tare weight.
• UNIT
Press this key to select the active units of measure.
• EXIT
Press this key to go back to the previous soft key set.
Following is a detailed description of the four functions listed above.
If you press the
DISP
soft key, follow these instructions:
1.
The display shows the current
display mode number. Press
ENTER
to accept this value or
key in a new number from the list
in Appendix 1, then press
ENTER
to accept it.
The display asks for the ACTIVE
VALUE. This is the active display
value.
2.
Choose one of the following
active display values by keying in
0-13, then press
ENTER
. . .
The display returns to the USER-
SELECT screen.
0 = Gross
4 = Max
8 = Count Total 12 = Piece Weight
1 = net
5 = Rate of Change
9 = Trans Total 13 = ADC
2 = Tare
6 = Gross Total
10 = Count
3 = Min
7 = Net Total
11 = Variable
If you press the
SCALE
soft key the display will ask you to select a scale
number. The currently active scale number is displayed. You can simply
type a new scale number and press the
ENTER
key. If you have multiple
scales attached to the indicator, this function chooses which scale's weight
is displayed and which one the
ZERO
and
TARE
keys will affect.
USER-CLOCK level
Enter the year using all four
digits.
USER-SELECT level
The display mode you pick
may not be the one that
appears on the display. A
display mode called out in the
WT BASIC program overrides
the setting you make through
the front panel.
While in the this level the
display will show USER-
SELECT in the top left to
remind you of where you are in
the USER level.
Variable (#11) is a variable
value called out in a WT-BASIC
program. ADC (#13) stands for
Analog to Digital Counts.
DISP (Display Mode)
SCALE
You cannot select a scale
number unless it has been
activated in the SimPoser
program and downloaded to
the TT-830.
Summary of Contents for TT-830
