Avery Weigh-Tronix TT-830, Service Manual

Page: 19 / 50

19
TT-830 Bench Scale Service Manual
2. Press YES to enable Harmonizer
or NO to disable the Harmonizer
parameter, then press
ENTER . . . The current Harmonizer Constant
value is displayed.
3. Press ENTER to accept this
value or key in a new value and
press
ENTER . . . The current Harmonizer Threshold
value is displayed. This value is in
calibration units.
4. Press ENTER to accept this
value or key in a new value and
press
ENTER . . . The display returns to the
CONFIGURE-MENU2 display.
If you press the TMOUT soft key, follow these instructions:
1. The current value for
Accumulate Timeout is
displayed. Press
ENTER to
accept this value or key in a new
value and press
ENTER .
2. Repeat step 1 for Print Timeout,
Zero Timeout, and Tare
Timeout. . .
The display returns to the
CONFIGURE-MENU2 display.
Press the EXIT soft key to return to the CONFIGURE display.
Press the MENU3 soft key to access the following soft key group:
• KEYS Press this key to enable or disable front panel keys.
• VALS Press this key to enable or disable the display values
(gross, net, min., max., ect.)
• DMODE Press this key to pick a power-up display mode from the
over 35 available. See
Appendix 1: Display Samples .
• EXIT Press this key to go back to the previous soft key set.
Following are detailed instructions for setting these parameters.
If you press the KEYS soft key, follow these instructions:
1. The current setting (enabled ON
or OFF) for the
SELECT hard
key is displayed. Press YES to
enable the key or NO to disable
the key, then press ENTER . . The current setting for the UNITS
hard key is displayed.
TMOUT (timeout)
CONFIGURE- MENU 3 Level
KEYS
When your changes are
completed, secure and protect
them by changing the seal
status. See
Seal .
The display will ask for a scale
number if Multiscale is enabled.