Avery Weigh-Tronix E1070, Service Manual

Page: 106 / 164

106 E1070 Service Manual
3 Using the Menus
* Bridge tokens that are inbound to net2 can be outputs for net1
** Bridge tokens that are inbound to net1 can be outputs for net2
Bridge1 X** X* X* X** 30 1E
Network BRIDGE tokens. These allow data
to be mapped from NETWORK#1 to
NETWORK#2 or from NETWORK#2 to
NETWORK#1.
* Bridge tokens which are INBOUND on Net
2 can be OUTBOUND on Net 1.
** Bridge tokens which are INBOUND on
Net 1 can be OUTBOUND on Net 2.
Bridge2 X** X* X* X** 31 1F
Bridge3 X** X* X* X** 32 20
Bridge4 X** X* X* X** 33 21
Bridge5 X** X* X* X** 34 22
Bridge6 X** X* X* X** 35 23
Bridge7 X** X* X* X** 36 24
Bridge8 X** X* X* X** 37 25
Bridge9 X** X* X* X** 38 26
Bridge10 X** X* X* X** 39 27
Bridge11 X** X* X* X** 40 28
Bridge12 X** X* X* X** 41 29
Bridge13 X** X* X* X** 42 2A
Bridge14 X** X* X* X** 43 2B
Bridge15 X** X* X* X** 44 2C
Bridge16 X** X* X* X** 45 2D
Indicator
Healthy X X 46 2E
Output of 2 bytes to the network indicating any
faults in the indicator. When no errors, the value
output to the network is 0xFFFF.
Byte#1:
Bit#0 = Any Fault
Bit#1 = ADC Error
Bit#2 = SRAM ErroR
Bit#3 = EEPROM Error
Bit#4 = N/A
Bit#5 = Overload
Bit#6 = Underload
Bit#7 = N/A
Byte#2:
bit#0 - bit#7 is not used at this time.
Inmotion
Specials X X 47 2F
Inmotion
Special X X 48 30
Weight for
Setpoint #1 X X X X 49 31 Input from network to change the weight of
OUTPUT#1 or an output to the network to
view the weight value of OUTPUT#1
Weight for
Setpoint #2 X X X X 50 32 Input from network to change the weight of
OUTPUT#2 or an output to the network to
view the weight value of OUTPUT#2
Weight for
Setpoint #3 X X X X 51 33 Input from network to change the weight of
OUTPUT#3 or an output to the network to
view the weight value of OUTPUT#3
Table 4 Tokens
Token
Inbound
to net1
Outbound
from net 1 Inbound
to net 2
Outbound
from net 2 Token
(dec.)
Token
(hex)
Description