Avery Dennison SNAP 600, User Manual

Page: 42 / 141

42
User’s Manual—SNAP™ 600 Printer
Label Stop
Platform
Adjustment Pin
Figure 15. Stacker Platform Angle Adjustment
4.3 Print and Cut Adjustments
The print and cut adjustments allow you to compensate for mechanical
tolerances in the printer so that the print is positioned correctly and the cut
occurs at the right place.
4.3.1 Cut Adjust
NOTE: The cut adjust should only be made when using pre-
printed stock (see section 3.3.6). If the cut adjust is changed
when you are using blank stock, the print will appear to move
on the label.
If you use pre-printed stock, do the cut adjust using the pre-
printed stock and then do the print adjust using either pre-
printed or blank stock.
If you never use pre-printed stock, set the cut adjust to zero.
The cut adjust allows you to adjust the cut position so that it cuts in the right
place with relation to the sense mark on pre-printed stock.
The cut adjust may be made two ways: using the Virtual Control Panel (sec. 8.0)
in PCMate Platinum, or using the Remote Front Panel (sec 7.0). In the Virtual
Control Panel, the cut adjust is found on the Options tab. On the Remote Front
Panel, the cut adjust is found under the Print/Cut Adjust menu item.
When the cut adjust is set correctly, the printer will cut the label at the leading
edge of the sense mark. If the cut is not in the right place, increase the cut adjust
value to move the cut to the right (looking at the printer) or decrease the value to
move the cut to the left. Each step is 0.003”/0.076mm.