Avery Dennison SNAP 600, User Manual

Page: 25 / 141

User’s Manual—SNAP™ 600 Printer
25
3. To install the stock supply roll, begin with the leading end at the top of the
roll.
4. Slide the stock supply roll onto the Stock Arbor (see Figure 9).
5. Rotate the knob counter-clockwise quickly to extend the retraction fingers
that hold the supply roll in place.
6. With both print rollers in the open position, pull the stock from the top of the
supply roll, and over the Decurler Roller.
Figure 9. Stock Supply Through Print Stations
7. Pull the roll of stock under the stock (web) guides.
8. Continue threading the stock between the print rollers and through the feed.
9. Rotate the black knob on the feed counter-clockwise and advance the stock
through the knife and nip rollers and into the stacker (until it extends about
½ inch or 10 mm - 15 mm from the rollers).
10. If the stock will not advance through the knife, refer to Section 5.4.2, Knife
Home Position Adjustment.
11. Close the upper and lower print rollers.
12. Rotate the stock web guide knob to align it to the stock width.
13. Tighten the stock arbor knob to apply tension to the stock.
Stock (Web) Guide
Decurler Roller
Retraction Fingers
Upper Print Station
Lower Print
Station
Stock Arbor