Avaya one-X 1603SW, Administrator'S Manual, Page: 95 / 124

Link Layer Discovery Protocol (LLDP)
Issue 1 June 2010 95
L2Q, L2QVLAN,
L2QAUD,
L2QSIG,
DSCPAUD,
DSCPSIG MED Network
Policy TLV L2Q - set to “2” (off) If T (the Tagged Flag) is set to
0; set to “1” (on) if T is set to 1.
L2QVLAN - set to the VLAN ID in the TLV.
L2QAUD and L2QSIG - set to the Layer 2 Priority
value in the TLV.
DSCPAUD and DSCPSIG - set to the DSCP value
in the TLV.
A check is made as to whether a reset is necessary
to obtain a new IP address due to a change in the
values of the parameters L2Q or L2QVLAN.
This TLV is ignored if:
●
the value of USE_DHCP is “0” and the value
of IPADD is not “0.0.0.0”, or
●
the Application Type is not 1 (Voice) and is
not 2 (Voice Signaling), or
●
the Unknown Policy Flag (U) is set to 1.
TLSSRVR and
HTTPSRVR Proprietary File
Server TLV TLSSRVR and HTTPSRVR will be set to this value
if neither of them have already been set.
L2Q Proprietary 802.1
Q Framing The default L2Q is set to the value of this TLV. No
change is made to the current L2 tagging, but the
new default value is used on the next reboot. If TLV
= 1, L2Q set to "1" (On). If TLV = 2, L2Q set to "2"
(Off). If TLV = 3, L2Q set to "0" (Auto).
Proprietary - PoE
Conservation TLV This proprietary TLV can initiate a power
conservation mode. The telephones that support
this will turn on/off the telephone backlight and the
backlight of an attached Button Module in response
to this TLV.
Extended
Power-Via-MDI Power conservation mode will be enabled if the
received binary Power Source value is 10, and
power conservation mode will be disabled if the
received binary Power Source value is not 10.
Power conservation mode is enabled even if the
telephone is not powered over Ethernet because
the telephone sends information about the power
source that it is using in a TIA LLDP MED Extended
Power-Via-MDI TLV; it is assumed that the power
management system intends to conserve local
power as well.
Table 14: Impact of TLVs Received by 1603SW-I SIP IP Deskphones on System Parameter
Values (continued)
System
Parameter Name TLV
Name
Impact