WLAN IP Telephony Handset Users Guide
NN40011-039 Issue 1.2 BCM Rls 6.0
41
Note:
Contact your system administrator for a list of line pool codes. PRI lines
do not support line pool access codes; they must be configured as a
destination code. When entering a destination code on PRI lines
you will not hear dial tone.
Internal calls using intercom buttons
1. Press to go off-hook.
2. Press to access the Feature menu.
3. Press a number key (1 through 6) corresponding to the desired
intercom key.
4. Dial the extension number.
Answer Calls
When your handset rings or vibrates, a line number on the display flashes,
and the display shows
information about the call, such as the caller’s name
and extension:
Press .
Hold
While on a call, press and
2
.The indicator for the line on hold
flashes.
To retrieve a held call, press , while in the active (off-hook) state.
Then press the number key corresponding to the flashing line number.
Headset
You must have a headset installed on your handset to use this feature.
Connect the headset to the headset jack.
To answer a call with a headset plugged into your handset, press any
key other than
Power On/Start Call
,
Power Off/End Call
, the soft
keys, or the
Up/Down/Select
buttons.
Mute
While on a call, press and
1
to turn the microphone off.
Do the same again to turn the microphone on.
End calls
You must end every call, by pressing the
Power Off/End Call
key, to release
system resources and allow the WLAN Handset to function properly.