deskphones. For example, pressing button
2
initially
enters a
2
, followed by
A
,
B
,
C
, and back to
2
. Pressing
button
3
initially enters a
3
, followed by
D
,
E
,
F
, and back
to
3
.
Proceed to the next step.
To change the 802.1Q
value
Use the Right navigation arrow to navigate through the
text strings corresponding to the L2Q values defined as
Auto
if L2Q=0,
On
if L2Q=1, and
Off
if L2Q= 2 until the
text string of the value you want to change to displays.
Proceed to the next step.
To change the VLAN
ID value
Use the dial pad to enter the new static VLAN ID of from
0 to 4094, inclusive. Proceed to the next step.
To change the
VLANTEST value
Use the dial pad to enter the new value of the
DHCPOFFER wait period of from 0 to 999. Proceed to
the next step.
4. Press
Save
to store the new setting and redisplay the Craft Local Procedure screen
or
Cancel
to return to the Craft Procedures screen without saving the value
entered.
Once the new values are stored, the deskphone is reset.
Calibrating the touch screen
About this task
Use screen calibration for proper alignment of the touch screen if a significant problem with
the touch screen arises.
Important:
Use a stylus instead of your finger to touch the calibration points precisely.
Note:
The CLEAR Craft procedure clears any calibration data set using the CALIBRATE SCREEN
Craft procedure, but does not change factory settings of calibration data. Use the
Default
softkey to restore factory-set calibration. You cannot save calibration results as part of a
backup operation.
Perform the following procedure to calibrate the touch screen:
Calibrating the touch screen
Installing and Maintaining Avaya IP Deskphone H.323 9608, 9611G, 9621G, and 9641G
August 2013 49