13
3.
Code number 09 programming Code (Installer Code)
- Code No. 09 enables
entering into programming mode (system features programming) at Installer level.
The factory default programming code is ‘1 9 9 4.’
The programming code may be installer-programmed. Installer code does not Arm or
Disarm system. Refer to setting new programming code section.
4.
User Codes
- (Arming and Disarming code). Each code consists of 1 to 6 digits.
System provides eight user programmable codes.
5.
Key Visual Feedback -
Visual ‘feedback’ from the keypad display upon entering of
code. This feature indicates the code entry progress and is most practical when the
keypad buzzer is disabled at Group Bypass mode, or if selected by programming.
Code entry by user or installer is confirmed at keypad display. Display segments will
light up clockwise, indicating the sequence of the digits entered.
Typing six erroneous codes will lock the keypad keys for 60 seconds
4.2 Enter user programming & Set New User Code
In user programming mode user is able to: Set clock, set SMS and dialer number (not
CS numbers), and change user codes 01 to 08.
1. Hold down key
8
Program
2. While the four LEDs are blinking, enter code No. 1 (factory default 1 2 3 4)
3. If code is valid, u (small U) is displayed
4. The 2 left-most LEDs blink to indicate that the system is waiting for a new user code
index (user 01 to 08) to be entered
5. Enter the code index from 01 to 08 (01 for code No. 1; 02 for code No. 2, etc.)
6. The 3 right-most LEDs blink to indicate that the system is waiting for a new code (from
1 to 6 digits) to be entered.
The code is voided if user code not entered.
7. Enter the new code; new code and user index 'u' is displayed for confirmation. If
during 60 seconds data not entered system automatically escape from code setting.
8. To quit code setting hold down key 9.
4.3 SMS and dialer number entry by user
For SMS number: Hold down "6" then hold down "1" (SMS No. 1), enter the number,
same for SMS numbers 2, 3, 4.
For telephone numbers: Hold down "6" then hold down "5" (Telephone No. 1), enter the
number, same for telephone numbers 2, 3, 4.
4.4 Installer Programming mode & Code change (code 33)
1. Hold down key
8
Program
, w
hile the four LEDs are blinking, enter 1994 (default code)
“P” displayed, 2 left-most LEDs blinking.
2. While system is in installer program mode
3. Enter 099, u (user number) displayed, press 33 then the new programming code, U
(big U) displayed to confirm
4. New code displayed for conformation. System reverts to Installer Programming mode.
5. Hold down key 9 to exit programming mode.
4.5 Delete a User Code
1. Hold down key
8
Program
Summary of Contents for AV-5000 GSM
Page 32: ...32 ...
