Automatismos Pujol SPIDER PRO 600, Installation And Adjustment Instructions

Page: 24 / 28

automatismos pujol -
6
- english
SPIDER PRO 600
OPERaTING TEST
using the remote controls
fig. 16
Obstacle detection operation
fig. 17 and 18
When an obstacle is detected during closing, the door re-opens (Fig. 17).
When an obstacle is detected during opening, the door will stop (Fig. 18).
Check that the obstacle detection function works when the door encounters a 50 mm high obstacle on the ground.
Integrated lighting operation
The lighting comes on each time the motorisation is switched on. When the door stops moving, it goes off automatically after 30 seconds. Repetitive
use will cause the light to be lit constantly which may result in the light being switched off automatically due to thermal protection.
CONNECTING aDDITIONal DEvICES
Description of the various additional devices
fig. 19
No. Description
1 Orange light
2 Wired code keypad
3 Key lock
4 Aerial
5 Battery
6 Photoelectric cells
Electrically connecting additional devices
fig. 19 to 22
Switch off the electrical supply to the motor before performing any operation on the additional devices.
General electrical diagram (fig. 19)
Photoelectric cells (fig. 20)
When positioning the cells, remove the bridge created between terminals 1 and 2.
If cells are removed, it is essential to recreate the bridge between terminals 1 and 2.
Solar kit (fig. 21)
Activate solar mode by adjusting the motor supply type (see below).
Wired code keypad (fig. 22)
PaRamETER SETTING aND OPERaTING OPTIONS
General parameter-setting diagram
fig. 23
meaning of different parameters
Programming example: Adjusting the long slow zone (Fig. 24)
Warning light a Description Warning light B Comments
Obstacle detection
sensitivity
1 : very low sensitivity
2 : slightly sensitive
3 : standard
4 : very sensitive
If this parameter is modified, it is essential to perform the
force measuring procedure at the end of the installation
operation.
Coupling speed when
closing
1 : no reduction in speed
No reduction in speed at the end of closing.
2 : short reduction in speed
The speed is reduced during the last 30 centimetres.
3 : long reduction in speed
The speed is reduced during the last 50 centimetres.
If this parameter is modified, it is essential to perform the force
measuring procedure at the end of the installation operation.
Auto-programming mode
2 : waiting for auto-programming
Power supply type
1 : Power supply
2 : Solar
https://appceso.com