AutoGate VPG-24 (LM), Installation & Operation Manual

Page: 26 / 42

1.800.944.4283 AutoGate Technical Support
JULY 2016
26
ELECTRICAL QUICK CHECK GUIDE
Follow the steps in this chart to see if you can restore service of your gate.
This is a visual check without the use of a voltmeter.
Start by opening the cabinet door to the operator.
Then open the electrical control box and look on the control board for the HBEAT LED,
located at the lower left corner of the control box.
HBEAT
LED on
Steady
HBEAT off-
Check
A/C PWR
LED
A/C
PWR LED
ON?
Check BATT
LO LED
Control Board is
defective
Replace Control
Board
Check A/C
Switch
Is
Switch On?
Is HBEAT
LED flashing
or ON
Steady?
Off/On Steady
Flashing
NO
YES
YES
Batteries Low
or Bad
Check input LED’s on
top Right Side of
Control Board
Any input on Will hold
gate open
Recharge or Replace Batteries
Check Wiring and Charging Output
Gate will not close if BATT LO LED is on
Replace any blown fuse with same Sizing and Rating. If fuses are
good—Check for good batteries and A/C from building circuit breaker.
If any fuse blows instantly at power on—Bad Circuit Board
REPLACE
ON
Turn On
A/C Switch
Is HBEAT LED
On or
Flashing?
Check Fuses—
3 Amp on front of
Battery Tray
F3 Fuse on
Control Board
NO
NO
YES
On Steady
Flashing