AutoGate VPG-24 (LM), Installation & Operation Manual

Page: 14 / 42

1.800.944.4283 AutoGate Technical Support
JULY 2016
14
PREPARATIONS PRIOR TO INSTALLATION
RECOMMENDED TOOLS AND EQUIPMENT
Lifting Strap Multi-Meter (DCV & AMPS)
Hammer & Level Hammer Drill, 1/2 & 5/8 Bits
Grease Gun, Lithium Grease Tape Measure
Screwdriver Sets (Flat & Phillips) ½” Drive Socket Set: 1/2”, 9/16”, 3/4”, 15/16”, 1-1/8”
Electrical Tape Open End Wrenches: 1/2”, 9/16”, 3/4”, 15/16”, 1-5/16”
Wire Cutters/Strippers Misc. Electrical Connectors
Chalk Line Batteries (2) 12 VDC Group 24 Deep cycle marine
NOTE : Refer to manufacturer’s instructions of Accessory Equipment for correct wire size and type.
RECEIVING & UNLOADING INSTRUCTIONS
Unloading & Unpacking - Gate weight per foot varies with gate style & height and are approximate. Operator
weighs1150 lbs., steel gates are 24 lbs. per foot and aluminum gates weigh 19 lbs. per foot.
1. Have adequate equipment ready to unload your Gate and Operator safely. Utilize a Liftgate service when
available from the LTL carrier.
2. Before removing your Gate and Operator from the truck, inspect it for any visible damage and make sure
the Gate Box was shipped upright. (DO NOT DROP EITHER GATE OR OPERATOR BOX). Photograph
and retain if damaged as well.
3. After uncrating your Operator, locate and remove the door lock keys attached to the Transport/
Maintenance (T/M) Safety Pin. DO NOT REMOVE T/M PIN. ONLY REMOVE HAIR PIN RETAINER TO
REMOVE THE KEYS THEN REPLACE HAIRPIN. (See Figure 2.3)
4. Any transmitter, antenna, or other ordered accessories will be boxed inside your operator cabinet.
5. Unpack gate panel crating very carefully.