AutoGate VPG-24 (LM), Installation & Operation Manual

Page: 15 / 42

1.800.944.4283 AutoGate Technical Support
JULY 2016
15
INSTALLATION
Installing VP Gate and Operator
1. Position Gate on Operator Arm.
2. Use (1) SS 3/4”-10 x 4 1/2” (STEEL GATE) or (1) SS 3/4”-10 x 5” (ALUMINUM GATE) Bolt for the top
connection. Use (4) SS 1/2 x 1-1/2" Bolts for the bottom connection.
3. Insert the top bolt first and then the bottom four (4) bolts finger tight. Be certain gate is properly aligned
before tightening. Tighten bottom bolts first, then tighten top bolt.
4. Locate washers and Linkage Pivot Bolt (5/8" x 2-1/4") and insert through rod end fitting and tighten bolt into
the gate lug hole as shown below. You may have to push down on the gate to insert Linkage Bolt.
Lifting Gate & Operator
To lift Gate & Operator use a lifting strap. The strap should be secured around Operator Arm and T/M Safety
Pin or the top rail of the gate near the operator arm. See Figure 3.2 & 3.3
Figure 3.2 Figure 3.3
NOTE : It is recommended to attach Gate to Operator Arm before lifting (for better balance), but it is not mandatory. If
using a Forklift to position Operator only, lift from sides only! Do not try to lift gate and operator together from the side
Positioning Gate Panel/Drop Arm & Operator
Refer to the site drawing for your specific order as there may be details unique to the installation.
1. Place Gate & Operator Assembly on pad so the end of the Gate is centered over the Yoke pad or intended
yoke position for the site (for yoke styles mounted to posts, buildings, etc.). Allow a minimum three (3")
inches from edge of pad to bolt holes to prevent concrete damage
2. Position and align Pad Yoke and center under gate.
3. Secure
Operator with (1) 5/8" dia. Wedge Bolt in rear; check alignment on pad as well as gate panel/Drop
Arm alignment before installing remaining anchor bolts.
4. Install remaining four (4) 5 1/2” x 5/8" dia. Concrete Anchor Bolts provided, ( level Gate Panel/Drop Arm
and Operator on pad, if necessary).
5. Secure Yoke with four (4) 1/2” dia. Anchor bolts (provided). If installing a Ground Yoke, allow a minimum
space of two (2") inches between bottom of Gate and Yoke.
Figure 3.1
Figure 3.1