AutoAnchor 560, Owner'S Manual

Page: 20 / 41

Select Rope per turn.
Enter the measurement in mm or metric inches
(depending on the units selected).
Save and return to Rode Set up. There are no further
settings.
Exit to Windlass Set up. Press twice to exit to the Set Up
menu or hold for 2 seconds to return to the start screen.
3.7.6 To Enter the Rope per Turn
Setting:
3.8.1 Motor Driven Sensors
To select the motor driven sensor:
Scroll to Sensor.
Select Sensor.
Scroll to Motor driven reed.
Select.
Scroll to Gearbox ratio.
Select Gearbox ratio.
Increase or decrease the Gearbox ratio.
Save and exit to the Sensor set up menu.
Exit to the Windlass set up menu or hold for
2 seconds to return to start screen.
3.8 SENSOR SET UP
Default setting:
Standard - Applies to all AA sensors, reed switch
baseplate sensors and proximity sensors.
The default setting
should only be changed if you are using a motor driven sensor. (See
below).
Note:
The sensor is tuned to the system on first use. See page 21.
3.9 SWAP CONTROLS
Default setting:
= Up and = Down
Some operators prefer to use the buttons so that
= Out and = In
Access the swap controls feature via the Windlass Set up Menu.
Turn the AutoAnchor Off.
Hold together to access the Set up menu.
Scroll to Windlass.
Select Windlass.
Scroll to Swap Controls.
Select Swap Controls.
Exit to the Windlass Set Up or hold for 2 seconds
to return to start screen.
Note: This feature can not be used to correct wiring errors.