AutoAnchor 560, Owner'S Manual

Page: 23 / 41

Installation and set up must be complete and the anchor must be
docked before starting this process.
Clear the AutoAnchor to zero if necessary. (See page 24).
Deploy the anchor using the AutoAnchor. Initially the status bar will
display “
Sensor tuning”.
Continue deployment until this message
changes to
“Tuning done”. This must be done in one continuous
RSHUDWLRQZLWKRXWWDNLQJ\RXU¿QJHURIIWKHEXWWRQXQWLOWKH
“Tuning done” message displays. This could take up to 10 turns
of the windlass.
Retrieve the anchor to the docked position and clear
to zero if needed.
1RWH,I\RXGRQHHGWRWDNH\RXU¿QJHURII the button, start the
process again.
Rope/Chain Systems:
The default rode set up is chain only. If rope
and chain rode is selected without the correct sensor and magnet set
up a “Sensor installation not compatible with rope and chain setting”
message will display. Check the installation and rode set up and reset
the sensor to restart the tuning process.
4.3 SET UP AND TESTING
Before use the AutoAnchor must be correctly set up for the equipment it is to control
and then tested in a safe environment. The AutoAnchor will not count correctly if the
windlass selection is wrong or the windlass is not standard (eg it is installed with a different
chainwheel or motor).
4.2 USER PRECAUTIONS
It is the owner’s sole responsibility to ensure the AutoAnchor is installed, used and
maintained in a manner that will not cause accidents, personal injury or property damage.
When using the AutoAnchor the operator must use safe boating practices and safe
windlass/winch and anchoring operation
‡ XVHWKHZLQGODVVZLQFKVWULFWO\DFFR rding to the manufacturer’s instructions;
‡ RQO\SHUVRQVZKRDUHIXOO\DZDUHRIWKHFRUUHFWXVHRIWKHZLQGODVVZLQFK
should be allowed to use the AutoAnchor to control this equipment;
‡ WKHXVHUPXVWSHUVRQDOO\FRQWURODQGVXSHUYLVHDOODQFKRULQJRSHUDWLRQV
‡ WKHXVHUPXVWNQRZWKHORFDWLRQRIWKHPDLQEUHDNHURUEDWWHU\VZLWFKWR
disconnect the windlass/winch from all power sources in the event of an
emergency;
‡ WKHZLQGODVVZLQFKSRZHUVXSSO\PXVWEHWXUQHGRIIZKHQWKHHTXLSPHQWLVQRWLQ
use;
‡ WKHUHPXVWEHDQDOWHUQDWLYHPHWKRGDYDLODEOHWRRSHUDWHWKHZLQGODVVZLQFK
When Controlling a Windlass/Winch
• maintain a clear view of the windlass/winch, rode and/or anchor during operation;
• always ensure the anchor is fully
docked and secured
before moving the boat.
Required for all sensors other than a motor driven reed sensor. This screen automatically
displays on first use or if Factory Defaults are loaded, the sensor is reset or there has been
a loss of sensor signal.
4.3.1 PLUG & PLAY SENSOR TUNING